Joiner 6mm - Gold Series.  for 6mm rope.  joiner and mains connector

Equirope Joiner/connector - Gold series (must be use to retain Equrope guarantee) KV500C-G

The new custom Equrope joiner/connector for enhanced conductivity and vastly improved life of not only the joiner but the Equirope too. This product was designed to withstand the harshest conditions including near saline areas where other metals can experience corrosion.

The stainless steel screw, washer nd wingnut is designed so that any incoming supply wires or undergate wires can and must be connected by tightening the incoming wire under the washer. This is essentual to retaining guarantee on the whole Equirope system, as this connection method prevents bimetallic of galvanic reactions oftem caused by twisting supply wires directly onto the Equirope.

The design of this joiner ensures 28 points of contact with the interwoven conductors within the rope, so conductivity could never be better and with your supply wire connected under the washer, you could not get a better conection.

The material used to make these joiner/connectors is a custom blend of metals to give a join that creates no bimetallic or galvanic reaction between the joining block and the tin plated copper conductors within the rope, this joiner is a must to retain the guarantee on the Equirope system.

An added advantage is the stainless steel screw, preventing these screws rusting into the block, so these joiner/connectors can easily be re-used.

It is important to note, any joiners with galvanised or plated finish can and will cause corrosion of the conductors within the rope and you lose your guarantee if such are used on the Equirope.